How can an application find that a cisco phone has an active call?
We have an application that communicates with Cisco phones and pushes texts/images/.. to phones. Is it possible for the application to find out if there is an active call on the phone, before pushing a message?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.