04-27-2012 06:24 AM - edited 03-19-2019 04:49 AM
Hi ..
How do I connect a Cisco Unified Call Manager Express and Cisco Unified CallManager 8?
I think that has more to do some configuration than simply routes ....
Note: CME is running on a 2821 router and CUCM 8 is running on a VM, connected to arouter 3845.
Thanks!!!!!
04-27-2012 06:36 AM
Configure CME as an H323 GW and route calls as you would do to any H323 GW.
On CME configure dial-peers pointing to CUCM.
HTH
java
If this helps, please rate
www.cisco.com/go/pdihelpdesk
04-27-2012 06:41 AM
Hi Bruno,
Can you please try
Integrating Cisco Unified CallManager Express with Cisco Unified Call Manager
http://www9.cisco.com/en/US/docs/voice_ip_comm/cucme/srnd/design/guide/intcmecm.html#wp1072339
And also check out;
http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/srnd/8x/callpros.html#wp1044453
Cheers!
Rob
+5 for my friend Java (happy Friday "J-Man !)
04-30-2012 05:42 AM
Hi,
Thanks your help, however, remains to fix a problem ....
I'm managing to make calls from CUCM to CME normally.
But the links to CME CUCM are not doing at the time of connection, when I give the command "sh voice call status", I note that the link is not finding the correct codec. What can be?
Site_B#sh voice call status
CallID CID ccVdb Port Slot/DSP:Ch Called # Codec MLPP Dial-peers
0x5 11EA 0x49263FF4 50/0/1.0 5001 None 20 001/3
1 active call found
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide