Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

How do I connect a CUCM Express and CUCM 8?

Hi ..

How do I connect a Cisco Unified Call Manager Express and Cisco Unified CallManager 8?

I think that has more to do some configuration than simply routes ....

Note: CME is running on a 2821 router and CUCM 8 is running on a VM, connected to arouter 3845.

Thanks!!!!!

3 REPLIES
Cisco Employee

How do I connect a CUCM Express and CUCM 8?

Configure CME as an H323 GW and route calls as you would do to any H323 GW.

On CME configure dial-peers pointing to CUCM.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
Hall of Fame Super Red

How do I connect a CUCM Express and CUCM 8?

Hi Bruno,

Can you please try

Integrating Cisco Unified CallManager Express with Cisco Unified Call Manager

http://www9.cisco.com/en/US/docs/voice_ip_comm/cucme/srnd/design/guide/intcmecm.html#wp1072339

And also check out;

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/srnd/8x/callpros.html#wp1044453

Cheers!

Rob

+5 for my friend Java (happy Friday "J-Man !)

Community Member

How do I connect a CUCM Express and CUCM 8?

Hi,

Thanks your help, however, remains to fix a problem ....

I'm managing to make calls from CUCM to CME normally.

But the links to CME CUCM are not doing at the time of connection, when I give the command "sh voice call status", I note that the link is not finding the correct codec. What can be?

Site_B#sh voice call status

CallID     CID  ccVdb      Port        Slot/DSP:Ch  Called #   Codec    MLPP Dial-peers

0x5        11EA 0x49263FF4 50/0/1.0                 5001       None           20     001/3

1 active call found

1192
Views
5
Helpful
3
Replies
CreatePlease to create content