Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

How to access CRM connector PNP after installation ?

Hello,

I have a problem with the CRM connector. The Phone number processor of this CRM connector has a window for configuration. This window IS AVAILABLE ONLY when you install the server part of the connector. Then dissapears, or it seems to do so because i can not find it. I have to reinstall the server part to test the patterns which are on the connectors. Is very strange...

If someone can help with some advice, appreciatte a lot.

Thank you very much.

1 REPLY
New Member

Re: How to access CRM connector PNP after installation ?

We have the same problem, thanks for raising the issue.

What's the solution?????

81
Views
0
Helpful
1
Replies
CreatePlease to create content