How to configure a CRS application in the Voice gateway
I am very new to Cisco VOIP solution. We installed CCX software at our lab. We developed a sample application using CCX editor and we are able to invoke the application through CUCM extension.
I hope the IVR application developed using CCX editor can be directly called from the voice gateway, however no idea how to configure it. Hopefully we would need to supply the DN and service name to invoke the application. Could anyone help me with the steps how to do this?
It would able be beneficial if you share a document which will guide me through setting up in the voice gateway.
Re: How to configure a CRS application in the Voice gateway
You need to set up your gateway like any other voice gateway.
The UCCX application has a trigger associated with it, and this is a diallable number. You just need to ensure that the gateway can reach that number, and the required config will vary based on the type of circuits/service you have attached to it.
Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.