I have successfully setup CCUM 6.1 on VMWARE now i want to connect CUCM 6.1 with GNS3. I have started CCNA voice studies and i am following CBT NUGGETS tapology. please anyone suggest me how i can connect CUCM with GNS3???
I just forward you there because there are a number of different ways to integrate, and they have posts with good instructional videos that save us a ton of time. In a nutshell, you're using a GNS3 "Cloud" to connect your virtual/physical network to a specific port on your router (or switch).
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...