Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to hide a number on cucm 8.5

Hi guys,

I'd like to know how to hide the number of the caller on cucm 8.5

I'm not a pro, could someone explain to me step by step please
Thank you for ur time
Regards

Everyone's tags (4)
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

How to hide a number on cucm 8.5

OK, if you want to change this for all calls simply adjust "" to RESTRICTED on

all Route Patterns pointing to PSTN. If you want to do this only for some users you will need to copy all the route patterns and assign them different partition reachable from that phone.

If you want it to work on demend, i.e users dial *67 followed by the number to block caller ID, copy the existing route patterns and add *67 to the front and set this "" to RESTRICTED.

HTH, please rate all useful posts!

Chris

5 REPLIES
Hall of Fame Super Silver

How to hide a number on cucm 8.5

Are you asking to hind caller ID on outbound calls to PSTN, inbound calls from PSTN, calls between IP phones?

Chris

New Member

How to hide a number on cucm 8.5

I want to hide the numbers of the caller when he called out his company

Hall of Fame Super Silver

How to hide a number on cucm 8.5

OK, if you want to change this for all calls simply adjust "" to RESTRICTED on

all Route Patterns pointing to PSTN. If you want to do this only for some users you will need to copy all the route patterns and assign them different partition reachable from that phone.

If you want it to work on demend, i.e users dial *67 followed by the number to block caller ID, copy the existing route patterns and add *67 to the front and set this "" to RESTRICTED.

HTH, please rate all useful posts!

Chris

New Member

How to hide a number on cucm 8.5

awesome, work perfectly !

regards

New Member

It's not working on my CUCM

It's not working on my CUCM  8.6

My call setup below.

phone-cucm-sip trunk- ISP-(SBC-Genband) - cell phone

I created spereate rp and call is matchint correct rp fine i alwo selected under rp "Calling Line ID Presentation" to RESTRICTED but still seem caller id on cell phone.

755
Views
5
Helpful
5
Replies
CreatePlease login to create content