Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

HOW TO LOAD IOS INTO NM-CUE-EC ON 2811

Hello All,

Please I need everyone help on this one. it look simple but I am stock on this one. in a short summary.

I want to load an IOS into the above unit using the boot loader method. it is a new one. this is what I have done ( i have fellow the cisco link but I am unable to establish a connection to my tftp server)

1. Install the nm-cue-ec on the router

2. power on router.

3. assigne ip address to the router int fa0/0 as 10.4.19.142 255.255.255.224

4.assigne ip address to the nm-cue-ec ( int service-engine 0/1 as 192.168.1.2 255.255.255.0 )

5.I have all my ios on my tftp server.

6.session into the service-engine thru int 192.168.1.2

7.I am in the service engine

8.I enter *** to enter boot loader prompt

9. on the boot loader prompt I issue config

10. I input all the parameter

11. when I issue boot help to load ios from tftp server, I am unable to connect to my tftp server

12.I tried pinging my tftp server but I am unable to.

This is where I am stock as I have configure my boot loader as follows.

ip address 10.4.19.146

netmask 255.255.255.224

tftp server 10.4.19.130

gateway 10.4.19.129

the rest parameter as default.

Please any help will be highly appreciated.

1 REPLY
Hall of Fame Super Silver

HOW TO LOAD IOS INTO NM-CUE-EC ON 2811

The CUE modules dont run IOS, they run specific CUE installer via Linux.  IOS only goes on the actual host router where the module is inserted. 

HTH,

Chris

146
Views
0
Helpful
1
Replies