I've collected a couple of CallManager traces in order to do some troubleshooting. Is there any tool or software available to read the traces in a simple way? At this moment when I open the text file, I can see only codes. Any help will be highly appreciated.
those tools also decode the h323 and q931 messages, they show them in a readable format if you're not familiar with the way it shows in the trace which is a little messy but that's the way ASN1 was defined
there is one known as the triple combo that also does the trick
maybe this will show the info the way you're looking for, i know for sure this one can handle H225 and H245 message since it's the one i use when i want to look at messages from a specific call since it can filter them by protocol or call reference among others. i always end up reading the txt but it's a lot easier if you have the timestamps to look at when there are a lot of calls on the same file =)
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.