How to transfer calls on Analog Phones Behind a VG?

[dreis]

Is there any particular key set to press when you want to transfer a call to another extention number?

[Rob Huffman]

Hi Davi,

Call Transfer

Connects call to a third party that the phone user dials.

During an active call, user presses hookflash and receives dial tone. User dials number for transfer and either stays online to announce (consultive transfer) or hangs up (blind transfer). When user hangs up, the call is transferred.

http://www.cisco.com/en/US/docs/ios/voice/fxs/configuration/guide/fxssccpsplmft.html

Hope this helps!

Rob

[dreis]

That Sure Did Help.... but how about conference calls? Can I make Conference Calls using Analog Phones?

[Rob Huffman · Accepted solution]

Hi Davi,

Good stuff!

You would need to use SCCP for these features to work;

Check out Table 1 from this VG224 doc (show SCCP support for Conference);

http://www.cisco.com/en/US/products/hw/gatecont/ps2250/products_data_sheet09186a00801d87f6.html

Conference Call

Initiates a three-party conference.

During an active call, user presses hookflash for dial tone, dials a third party, and then presses hookflash again to connect all three parties

From this doc;

http://www.cisco.com/en/US/products/ps6441/products_feature_guide09186a0080483a76.html#wp1178205

Hope this helps!

Rob

[dreis]

Thanks again Rob.

Solved