Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

How to transfer calls on Analog Phones Behind a VG?

Is there any particular key set to press when you want to transfer a call to another extention number?

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Red

Re: How to transfer calls on Analog Phones Behind a VG?

Hi Davi,

Good stuff!

You would need to use SCCP for these features to work;

Check out Table 1 from this VG224 doc (show SCCP support for Conference);

http://www.cisco.com/en/US/products/hw/gatecont/ps2250/products_data_sheet09186a00801d87f6.html

Conference Call

Initiates a three-party conference.

During an active call, user presses hookflash for dial tone, dials a third party, and then presses hookflash again to connect all three parties

From this doc;

http://www.cisco.com/en/US/products/ps6441/products_feature_guide09186a0080483a76.html#wp1178205

Hope this helps!

Rob

4 REPLIES
Hall of Fame Super Red

Re: How to transfer calls on Analog Phones Behind a VG?

Hi Davi,

Call Transfer

Connects call to a third party that the phone user dials.

During an active call, user presses hookflash and receives dial tone. User dials number for transfer and either stays online to announce (consultive transfer) or hangs up (blind transfer). When user hangs up, the call is transferred.

http://www.cisco.com/en/US/docs/ios/voice/fxs/configuration/guide/fxssccpsplmft.html

Hope this helps!

Rob

New Member

Re: How to transfer calls on Analog Phones Behind a VG?

That Sure Did Help.... but how about conference calls? Can I make Conference Calls using Analog Phones?

Hall of Fame Super Red

Re: How to transfer calls on Analog Phones Behind a VG?

Hi Davi,

Good stuff!

You would need to use SCCP for these features to work;

Check out Table 1 from this VG224 doc (show SCCP support for Conference);

http://www.cisco.com/en/US/products/hw/gatecont/ps2250/products_data_sheet09186a00801d87f6.html

Conference Call

Initiates a three-party conference.

During an active call, user presses hookflash for dial tone, dials a third party, and then presses hookflash again to connect all three parties

From this doc;

http://www.cisco.com/en/US/products/ps6441/products_feature_guide09186a0080483a76.html#wp1178205

Hope this helps!

Rob

New Member

Re: How to transfer calls on Analog Phones Behind a VG?

Thanks again Rob.

Solved

424
Views
10
Helpful
4
Replies