I am working on a customer scenario where their call centre has this requirement:
1) An external DDI rings a Hunt Pilot which hunts through 12 agents and then goes to Voicemail for that Hunt Pilot (8700)
2) If someone dials any of the above 12 agents direct, then their CFB and CFNA is set to Hunt Pilot (8700) so that it hunts through and again goes to Voicemail.
I have tried using CF No Coverage settings but all the time they are getting generic call handler message and not the Unity message for mailbox 8700.
I have run port monitor and the call is coming in without any extension (check the attached image).
This is what I have done:
External Call --> 8800 >> Call Foward All (8700) & CF No coverage 1950 >> Rings Hunt Pilot 8700 >> At Hunt Pilot I have Forward Hunt No Answer/Busy checked >>> Hunts through 12 extensions >> each extension has CFNA/CFB (8700) and No Coverage (1950).
Ext 1950 is CF ALL to Voicemail.
Ext 8700 at Unity have Alternate extension 1950.
If you dial direct 1950, you can hear the correct Unity message.
If you dial 8700 direct, you will again get the same Cisco Unity messaging service, from the touch tone ......
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...