Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

incoming caller number based call routing

We are wanting to take our 1800 number and have a list of area code/prefix for incoming calls to detect and route to a local office.

We have 7 different offices.  If someone calls from XXXXXXXXXX want to route to this hunt group, if comes from YYYYYYYYYY go to this hunt group, if the number doesn't match any list, goes to everyone.  

Does anyone have a similar setup?  I have been searching for a couple of days through forums and haven't had much luck.

We are running call manager 10.5, about to upgrade to 11.

Thank you in advance.

Everyone's tags (1)
2 REPLIES

One option is to use the

One option is to use the "Route Next Hop by Calling Party Number" Translation Pattern setting. Here's a write up on using this feature:

http://dbenda-en.blogspot.com/2013/06/cucm.html

Another option of using an H.323/SIP gateway is to use translations on the gateway to accomplish the routing.

Brandon

New Member

Thank you.  I will check that

Thank you.  I will check that option out.

2
Views
0
Helpful
2
Replies