Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Installation Error - CUCM release 6.1(2)

we started a fresh installation, but it failed giving below error msg:

"The installation has faild and must be restarted to recover from failure. You may dump diagnostic information at this time to a USB storage key. Would you like to dump diagnostic information? "

I already restarted the server[MCS-7816] many times and each time the same error msg appears.

Kindly assist on above at the earliest..

S.Al Zaabi

5 REPLIES
New Member

Re: Installation Error - CUCM release 6.1(2)

i had the same problem

i just started an new installation and the problem was solved no error.

did you manual restart you server?

New Member

Re: Installation Error - CUCM release 6.1(2)

Thanks for your reply. yes i already restarted the Server, but no luck. the same error appears again and again.

New Member

Re: Installation Error - CUCM release 6.1(2)

I've got that problem because is manual restart my server after the installation.

then I started a new installation , installation started , I went home and the next morning I could login to cucm.

New Member

Re: Installation Error - CUCM release 6.1(2)

actually, this problem occurred during the installation. later i had to restart the server as instructed in the error msg, but with no use!

New Member

Re: Installation Error - CUCM release 6.1(2)

I have the same issue but with CUCM 7.0(1). How was this issue solved?

289
Views
0
Helpful
5
Replies