cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
755
Views
0
Helpful
7
Replies

Integration between CCM and UC520

Mohamed Sherif
Level 1
Level 1

Hi All,

We need to establish a connection between CCm release 4.0 and UC 520.

configuration from CCM side: we configure a H323 gateway to go directly to UC520

configuration from UC side: it's a simple dial peer

dial-peer voice 1000 voip
destination-pattern 6567
session protocol sipv2
session target ipv4:10.0.100.90
dtmf-relay h245-alphanumeric
!

we can call normally from CM to UC, but from UC to CM the call failed.

Could you help on this please.

Regards,

Mohamed Sherif

7 Replies 7

Howdy,

Can you verify the CSS on the h323 gateway is configured?

Hi Kevin,

We don't have any calling search space configured in the call manager, current configuration is none.

Thanks

Mohamed Sherif

Jaime Valencia
Cisco Employee
Cisco Employee

Make sure you have the command:

h323-gateway voip bind sr

That IP needs to match what you configured in CUCM under H323 GW.

EDIT: just as an FYI this is NOT supported.

Q. Can the Cisco Unified Communications 500 Series be networked with Cisco Unified
CME or Cisco Unified Communications Manager?
A. The Cisco Unified Communications 500 Series can be networked with an integrated services
router-based Cisco Unified CME, but the Cisco Unified Communications 500 Series does not
work with Cisco Unified Communications Manager.

http://www.cisco.com/en/US/solutions/ns339/ns637/networking_solutions_products_genericcontent0900aecd806122df.pdf

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

Hi javalenc

This command is there

h323-gateway voip bind srcaddr 10.1.2.1

10.1.2.1 is the same IP configured under H323 GW

Thanks

Mohamed Sherif

pratik.rb
Level 3
Level 3

It seems you are trying to integrate via the Voice gateway running SIP towards the UC520.

You will need to create similar dial-peer pointing to CM from the voice gateway and make sure this gateway has the following commands:

!

voice services voip

allow-connections h323 to h323
allow-connections h323 to sip
allow-connections sip to h323
allow-connections sip to sip

!
gateway

!

interface

h323-gateway voip interface

h323-gateway voip bind srcaddr

!

Ensure this IP address is added as H.323 gateway in CCM and have incoming CSS set (or if u are not using PT/CSS - none)

Hi Pratik,

these configuration is also there in the Voice Gateway

Thanks

Mohamed Sherif

Hi Sherif,

Please post both configs on VG as well as UC520 side.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: