i am having CUCM 7 at my end and CUCM 8.5 at another location. Earlier i was able to make successfull calls from either of clusters, but currently dial pattern has been change and i am not able to make calls from my CUCM cluster to another CUCM cluster.
I am having one another location and one trunk has been configured for the same and calls through that trunk are working fine.
I have just changed the dial pattern from one to another and not made any changes in trunks, route pattern,rute list or CSS. Can anyone guide here to what needs to be done to make successfull calls between two CUCMs clusters.
Customer have just changed the route pattern number 1241XXXX to 1201XXXX. In the dial number analyzer it does show that it is taking route pttern as 1201XXXX, but call is not getting connected. What can be the issue?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.