I have recently purchased VT camera III to enable video calls.
I installed video advantage software 2.2(1.7) on my PC, connected my PC behind 7942G IP Phone. Enabled PC port and video capability for the phone but still the IP phone is not displaying video icon. Video advantage software console shows that it is not connected to the phone. When I use IP communicator, i am able to see the video icon and the video advantage console shows that it has ditected IP communicator.
I verified and confirmed that CDP is installed on the PC NIC. I was able to ping the phone from PC and was able to telnet the phone IP on port 4224 successfully.
Thanks for your reply.... No, I am not using Extension Mobility. I even tried using a 6941 Phone but still i am not able to see the video icon on phone and when i browse through device information i see Cisco Video advantage disabled even though i have enabled it on the phone.
Where x.x.x.x is your publisher/tftp server, and the sep name is the name of your phone. Open the downloaded file in notepad, and see if it has 'videoCapabilities' set correctly. POst up the file if you aren't sure.
Please rate helpful posts...
Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...