Re: IPCCX 8.x can't log into Application after LDAP sync
Presumably you have verified that all the admin accounts have been deleted as they're not in AD?
Previous to ver 8 you would have run CET and set the system back to 'FRESH_INSTALL' mode; you can then run the initial setup wizard through by clicking next until the screen where you assign admin users.
On version 8 I believe you need to get TAC to run the tool for you...
Please rate helpful posts...
Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.