07-04-2013 11:49 AM - edited 03-19-2019 06:57 AM
Dear All,
I am using Cisco Unified CM Administration 9.1.1 and MOBILITY works fine.
However when somebody calls from external phone number into internal user number and MOBILITY option is ON and obviously, forwards the call for the user's cell.....in this case user can see only main company number, but not a caller number.
So, is there any option to change it?
Thank you
Solved! Go to Solution.
07-04-2013 01:57 PM
Go to the GW and run some debugs to find out exactly what you're sending, chances are, your telco is overwriting the original called number as it's nor part of your DID range.
HTH
java
if this helps, please rate
www.cisco.com/go/pdihelpdesk
07-04-2013 01:57 PM
Go to the GW and run some debugs to find out exactly what you're sending, chances are, your telco is overwriting the original called number as it's nor part of your DID range.
HTH
java
if this helps, please rate
www.cisco.com/go/pdihelpdesk
10-13-2013 12:21 AM
Hi Jaime,
You was right. GW sent to PRI correct data but telco blocked (by default) original number.
The issue was resolved after enabling on PRI the Screening Removal Feature.
Thanks,
Sergey
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: