Re: Is Unity4.2.1 demo version with 10 mailbox requiore license
This "Default" License file is one of two that can be used on a Demonstration system. It has a few less features than the "Time Limited" License available from Cisco, but is immediatly available during the install so you are good to go;
Installing a Cisco Unity Demonstration System
A demonstration system is a fully functioning version of Cisco Unity that has the limits noted in the "Limits on a Cisco Unity Demonstration System" section. A demonstration system uses one of two different license files:
Default license file (available on the Cisco Unity server).
Time-limited license file (must be ordered from Cisco).
Enabling a Cisco Unity Demonstration System with the Default License File
The default license file (CiscoUnity40.lic) is automatically copied to the Cisco Unity server during installation.
To Enable a Demonstration System with the Default License File
Step 1 Install Cisco Unity as described in the Cisco Unity installation guide-up to the point where the Install the Cisco Unity License Files screen appears in the main window of the Cisco Unity Installation and Configuration Assistant.
Step 2 Click Run the Cisco Unity Install License File Wizard.
Step 3 On the Welcome screen of the wizard, click Next.
Step 4 Click Add.
Step 5 Browse to the CommServer\Licenses directory, and double-click CiscoUnity40.lic.
Step 6 Click Next.
Step 7 In the Licenses list, confirm that the license information is correct.
Step 8 Click Next.
Step 9 Click Finish.
Step 10 Continue following the instructions in the Cisco Unity installation guide to complete the installation.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...