Jabber: Integrating CUCM, Unity Connection and MeetingPlace / WebEx Schedule.
I have installed the Cisco Jabber 9.0.1 Build 8802 on two desktops with Windows 7 Professional / Enterprise and I can use IM with file transfer, but can not make calls, integrating CUCM, Unity Connection and MeetingPlace / WebEx Schedule. Does anyone have any tips or Guide?
Jabber: Integrating CUCM, Unity Connection and MeetingPlace / We
Since there's no troubleshooter here there is nothing else than to look at all the settings.
I had a problem in my lab while deploying this in which my LDAP was not being recognized and had to configure manually the LDAP bind in the jabber config xml, but even with that, I could type in the DN from another phone or jabber client and call it. With that problem I couldn't right click on someone and call.
From what I have seen the reasons for this to happen are always missing steps from the guide, either no CTI GW associated, no CCMCIP profile, failed to associate user/DN/device, wrong group associations on CUCM, etc.
My CUPS/CUCM were already working fine for CUPC and I just followed the guide I sent you step by step to make this work, somethings I had to create/change, a lot was already in place.
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...