Using Jabber Client 10.5.1 on an iPad to connect into a CUCM cluster 9.1.2(SU2).
I have multiple TCT devices configured correctly on the CUCM cluster allowing me to run Jabber fine over iPhones across 802.11.
I can't seem to get any Ipads working though as it tells me it faills to get device configuration. If I try it full through IMP and then it registers for IM but no phone. If I just try phone it gives me this message.
Is their a device file I need to load or something I am not thinking of ? again it works great for iPhones just not so much on Ipads.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...
You have reached the Cisco Logistics Support Center.. To Check Status of your RMA, visit Product Returns & Replacements (RMA).
Need help? Contact us by Phone or Email.
Phone: 1800 553 2447 Option 4