Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Login Jabber

We are using employee number as userID in CUCM in LDAP sync. Can we login into Jabber with e-mail address instead of user ID? 

Regards,

Ali Can Karabas

Everyone's tags (2)
1 ACCEPTED SOLUTION

Accepted Solutions

Short answer is kind of, if

Short answer is kind of, if you change the Directory URI to be your mail address on the IM&P server (only available in version 10.x and above). You will run into issues like your phone accounts dont sync up, MRA will not work. This will be supported when the Jabber clients support multi-domain support, today its possible but you might end up breaking other stuff. 

Please rate useful posts.
2 REPLIES

Short answer is kind of, if

Short answer is kind of, if you change the Directory URI to be your mail address on the IM&P server (only available in version 10.x and above). You will run into issues like your phone accounts dont sync up, MRA will not work. This will be supported when the Jabber clients support multi-domain support, today its possible but you might end up breaking other stuff. 

Please rate useful posts.
Bronze

You can change your CM sync

You can change your CM sync from samaccountID to email but has a flow on impact such as extension mobility, user portal page, etc as George stated

73
Views
5
Helpful
2
Replies
CreatePlease login to create content