We have CM 6.1, have tried "calling Line ID presentation" to restricted on the route pattern, but this does not seem to work.
We have 2 requirements, firstly for all outbound calls to PSTN gateways we want to hide the calling number and secondly we have some GSM gateways that are in a route group, if a user dials 907xxxxxxxxx then the call is routed to the route group via a sip trunk, and for these calls we want to mask the number behind our default PSTN DDI.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.