Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MCS7835H2 - Factory Restore ?

I have a MCS7835H2 appliance that I booted and the UCM6 install has started. I want to do a factory restore on this so it is in original "out the box" condition. Is there a way I can do this ?

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Super Bronze

Re: MCS7835H2 - Factory Restore ?

Sure; use your UCM6 install disc and run the install again. When it asks if you want to perform initial config, select no and power the system off once it cleanly shuts down. This is the state Cisco ships it to you in.

Please remember to rate helpful responses and identify helpful or
2 REPLIES
Silver

Re: MCS7835H2 - Factory Restore ?

What troubleshooting has already been done? Is this a new install?

VIP Super Bronze

Re: MCS7835H2 - Factory Restore ?

Sure; use your UCM6 install disc and run the install again. When it asks if you want to perform initial config, select no and power the system off once it cleanly shuts down. This is the state Cisco ships it to you in.

Please remember to rate helpful responses and identify helpful or
115
Views
0
Helpful
2
Replies