Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Meeting place - Disconnect empty port

Hi,

In meeting place, Disconnect empty port controls till how much time the meeting(ports) will be available to the users.

The range is in minutes 0-30.

However, at my setup there have been many instances where the user does not join the meeting within Disconnect empty port time ( Mine is 30Min) and so the meeting ends.

Can we disable this parameter ? Or

Can we increase this to More than 1 Hour (60Min) ?

Thanks

Shashank

1 REPLY
Bronze

Re: Meeting place - Disconnect empty port

the Disconnect Empty port timer equals the number of minutes that ports are held after everyone hangs up.

This has been done to eg:accomodate longer meetings where people might want to take a break and then re-enter the meeting determines how long to hold ports, after scheduled start tiem, if no one shows for the meeting

For example, if the disconnect empty port is set to 20 minutes, if a meeting starts at 8 and goes to 8.15, at 8.35 the meeting is over.From that perspective you will want to make sure that you're not holding your ports too long.Though technically possible you will want to make sure not to block out ports too long because of this timer.

the ports of a long meeting are released under 2 conditions:

1. If the meeting has ended and the disconnect empty port time in minutes has been met

2. you end the meeting in then session tab

192
Views
0
Helpful
1
Replies