We are currently running MP 6.1 with CUCM 6.1.2. We are planning to upgrade our CUCM to 8.5 in the next couple of weeks but want to check the compatibility of MP6.1 with 8.5 CUCM. I have checked the CUCM compatibility Matrix which refers to the following URL:
I did some research and seems that MP6.1 should work fine with either SIP or H.323 with CUCM 8.x. Seems that there was not and official validation of these two versions together (not all the versions are tested with older MP versions).
I found this document, although it is not very clear:
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...