Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Meetingplace DMZ Internet access

I setup a Meetingplace 6.0 system in a SMA-2 Web configuration. Used FQDN in the Web server setup for the internal and dmz server. When you send a link to a person, they can click on the link and get into the home page. When they press the browser test link it is the ip address of the DMZ server secondary link, not the FQDN. The Internal server works with the FQDN. What am I doing wrong. Everything else works!

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: Meetingplace DMZ Internet access

To work around this problem, manually add the *.wsdl mapping back to the Application Settings of the web site.

This document provides the solution for when after you install Cisco Meeting Place Web 4.3.0.246.x DMZ-C, the Web Admin is unable to add the DMZ web server to the Site page

http://www.cisco.com/en/US/products/sw/ps5664/ps5669/products_tech_note09186a008039ef6c.shtml

2 REPLIES
Silver

Re: Meetingplace DMZ Internet access

To work around this problem, manually add the *.wsdl mapping back to the Application Settings of the web site.

This document provides the solution for when after you install Cisco Meeting Place Web 4.3.0.246.x DMZ-C, the Web Admin is unable to add the DMZ web server to the Site page

http://www.cisco.com/en/US/products/sw/ps5664/ps5669/products_tech_note09186a008039ef6c.shtml

New Member

Re: Meetingplace DMZ Internet access

Thank you very much, that worked.

121
Views
0
Helpful
2
Replies