I just installed MPE 2.0 and am having trouble getting it configure the way I want.
1) When I open a web meeting, all users by default are presenters. This means they get the option of sharing their desktop unless I manually make them an audience member. Is there a way to change the default on this so that everyone except the meeting organizer is an audience member?
2) What is the "Participant list only" option used for? When I select this option, nobody can share their desktop.
Hey Glenn, how are you? Are you using the default system profiles to enroll users or did you set up custom configurations? Profiles in MPE typically contain settings like User ID, permission type, and meeting preferences. The permission type is what determines whether users are hosts or participants. If you want to shoot me a look at what you have set up, I can take a look to see if I can be of assistance.
Participant list only. This is actually intended to be used when you have more voice ports than web ports. So, participant list only requires no licenses and reserves full web capabilities for users that need to actually share and collaborate via the web on the conference.
Thanks for the response. I guess what I don't understand is if I have someone attend a web meeting as a guest, they immediately get the option to share their desktop. I do not want to allow them to do this. I want to default everyone that logs in as guest to be an audience member, not a presenter. I sure there is a check box I'm missing somewhere but don't know where it is. I can send you my configs but not sure how to do this. Do you want screen shots?
Yeah, you can send screen shots. If you want to send me to my personal address - send me a PM and I'll provide that. I may be a little bit as I have some things in the pipe today but I can also try to look at another system to see if that helps me find what you're looking for.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.