So I was able to get the axl stuff to test good, but when I try to login with a user that is on my CUCM it tells me that user does not exist. Also I setup my gateway and route pattern on CUCM and configured the H.323 stuff according to the documentation in the wiki but when I dial the number I assigned I just get a busy signal.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.