Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Megacom not working for both LD and Int'l

I got the same issue described here https://supportforums.cisco.com/message/311063#311063 but only differences are my setup is using CCM 4.2 and Cisco 3845's.

To make a LD call to work, I got to set the "Called party IE number type" under the GW config to National; and

To make an Int'l call to work, I got to set this value to International.

If I leave everything default, i.e. Cisco CallManager, only LD works.

Basically, I couldn't make both LD and Int'l to work. It's either one way or the other.

Any workaround to make both to work would be greatly appreciated.

Thanks,

Kevin

128
Views
0
Helpful
0
Replies
CreatePlease to create content