08-09-2012 10:18 AM - edited 03-19-2019 05:21 AM
Hi Everyone
Can you anyone tell me what determines which CM sends the setup message to the gateway?
08-09-2012 12:21 PM
Yes using debug commands.
08-10-2012 05:04 PM
Debugs will definitely tell you what is really happening.
If you want to know from design point of view. Check out the srnd guides.It is dependent on CUCM version, route list config, gw protocol, direction of call, where your phone is registered.
In particular look up run on all nodes. Nice new feature for optimizing this.
Cheers,
Tim
Sent from Cisco Technical Support iPad App
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide