Messages button giving "Service not configured" error
I have created my voice mail ports, LG,HL and HP. I also created voice mail pilot and profile, assigning the pilot to profile and then assigning profile to the line of the IP Phone.
I can dial the pilot number and voice mail port numbers, but when I push the "Messages" button on the IP Phone, I get service not configured. I looked at enterprise parameters for messages and noticed that the URL was missing. Can someone post what the URL should be for messages under enterprise parameters?
Any other ideas as to why I am getting this error?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...