Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MGCP Gateway doesn't register when layer 1 deactivated

Hello, I'm from Bosnia, and here BRI Layer 1 gets deactivated when there is no active calls (point-to-multipoint). I can activate it with call, from outside. Problem is that CUCM 4 wan't route call on that gateway from inside because it's unregistered, even it's fully functional. Besides, asking Telco to provide point-to-point ISDN, is there any way to force call from inside through this gateway? Router c2801, C2801-ADVENTERPRISEK9 12.4(11)T. Thank you.

Sasa

152
Views
0
Helpful
0
Replies