CUCM 6.0(1). I have configure Mobile Connect for my phone. I have added a couple of destinations. Calls are not being exended and when I hit the soft key, I get a message saying "You are not a valid Mobile Phone user"
I have the "Enable Mobility" box checked for my user. I have the numbers in my remote destinations profile.
I'd check to make sure you have the Directory Number Association as the Primary Extension on your phone. Also, you need to set the primary user device to your phone (your device name) - should be the same as your controlled device.
Both of these are done on the end user configuration page.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...