Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Mobility Manager 1.2(4) and CCM 5.1 shared line link, outgoing port

Hi,

I ve created the 2 user and cti pool, the rp but the root point still not Oregisterd on the CCM. And on the mobility the two links are Out Of Service.

Any idea about this ?

Regards

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Mobility Manager 1.2(4) and CCM 5.1 shared line link, outgoi

Can you enable the JTAPI auto update, so you will have the correct JTAPI version working with CCM 5.1.

7 REPLIES

Re: Mobility Manager 1.2(4) and CCM 5.1 shared line link, outgoi

Have you associated the cti ports with the mm_shared/mm_out user (dont remember which user - please check the documentation) ? Try restarting CTI manager service on CM server and Mobility manager service from MM server.

New Member

Re: Mobility Manager 1.2(4) and CCM 5.1 shared line link, outgoi

We have associated one user with the RP and the shared line and another user with the cti outgoing. We ve restarted MM and CCM, but the RP is not registered.

Cisco Employee

Re: Mobility Manager 1.2(4) and CCM 5.1 shared line link, outgoi

Can you enable the JTAPI auto update, so you will have the correct JTAPI version working with CCM 5.1.

Re: Mobility Manager 1.2(4) and CCM 5.1 shared line link, outgoi

Good catch Marcos, That is something that was told by TAC to set me when i had similar issues.

New Member

Re: Mobility Manager 1.2(4) and CCM 5.1 shared line link, outgoi

Hi thanks fo your reply,

Could you explain me what i should enable fo the jtapi. Is there something about this in the documentation.

Regards

Nicolas

Re: Mobility Manager 1.2(4) and CCM 5.1 shared line link, outgoi

This setting can be fiound under Mobility manager system parameters.

New Member

Re: Mobility Manager 1.2(4) and CCM 5.1 shared line link, outgoi

Hi,

Thanks a lot, I ve enabled the jtapi autoupdate, and the links comes up!!

Regards

Nicolas

120
Views
0
Helpful
7
Replies
CreatePlease to create content