cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
681
Views
5
Helpful
8
Replies

Mobility Manager Configuration Guide for CUCM 6.X

steve-parrish
Level 1
Level 1

Hi,

Can someone please point me in the right direction.

I am looking for the configuration guide for Mobility Manager for CUCM6

I am having issues when calling into voice access from the mobile phone, authenicating OK, then pressing "1" to dial an extension number. The call clears down as soon as the # is entered after the extension number.

Can someone please help

Thanks

Steve

8 Replies 8

Jaime Valencia
Cisco Employee
Cisco Employee

you can find the guide here:

Maintain and Operate Guides

http://www.cisco.com/en/US/products/sw/voicesw/ps556/prod_maintenance_guides_list.html

HTH

javalenc

if this helps, please rate

HTH

java

if this helps, please rate

shingphing_2
Level 1
Level 1

Steve,

Did you managed to resolve as I have the same problems

Regards,

Hi

check your CSS on the Remote Destination

also make sure your codec's negotiated ok

Steve,

I did not configure any css and partition.mobile connect works fine.

Regards

I found MVA uses the CSS on the RD to allow calls through option "1", (not the reroute CSS)

thks .but all my css and partition are set to "none".do you thk these will affect the option "1" routing.I have no problem calling out from phones.Call options 1 call internal extension?

Try using DNA with the RD Extension number and ensure you can make all necessary call types

thks .In fact i have a ip communicator with the RD extension which have no problems making outside calls.

Have a pleasant day !!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: