Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MOH Question

HI Everyone

I'm working on a project where I have to remove all of the CUCM nodes from 10 sites and have them connect back across the WAN to a PUB&SUB setup.I wanted to know what type of options would I have for their MOH once I remove the boxes from the locations.

Eric

2 ACCEPTED SOLUTIONS

Accepted Solutions
Cisco Employee

Unicast, multicast from CUCM

Unicast, multicast from CUCM or SRST as MOH

HTH

java

if this helps, please rate

www.cisco.com/go/pdi

The CUCM piece is pretty

The CUCM piece is pretty simple.  On the network side, you would need to enable multicast across the WAN to these various locations.

5 REPLIES
Cisco Employee

Unicast, multicast from CUCM

Unicast, multicast from CUCM or SRST as MOH

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

JaimeNone of the routers have

Jaime

None of the routers have SRST enabled on them and they told me that they don't want it enabled. Why I don't know but is there any documentation on how to enable either the unicast or muticast MOH from CUCM.

Eric

Cisco Employee

Yes, review the features and

Yes, review the features and services guide for your CUCM version.

HTH

java

if this helps, please rate

www.cisco.com/go/pdi

The CUCM piece is pretty

The CUCM piece is pretty simple.  On the network side, you would need to enable multicast across the WAN to these various locations.

New Member

DavidI'm looking at the MOH

David

I'm looking at the MOH options now and I have a question, I went to the MOH audio source and the MOH server configuration. And I see that each one has an option to allow multicasting, but in the server configuration they have base multi-cast IP and base mutli-cast port. I wanted to know is th IP 239.1.1.1 and what would I put for the port.

Eric

50
Views
0
Helpful
5
Replies
CreatePlease login to create content