Moving Secondary Failover server to another location
I have two Unity servers configured for failover, primary and secondary. Currently both are located at the same loacation on the same network, I will be moving the secondary server to our DR location in Tx and the IP address on this server will be changed.
Is there anything that I need to watch for when changing the IP address for failover to work properly ?
has anybody done this before ?
the two servers will be connecting over a 10M wan link. Thanks in advance !!!
Re: Moving Secondary Failover server to another location
no, I currently have a single server running Unity 4.0.3 with Exchange on box and in the process of separating Unity from Exchange and reinstall it onto a separate server and at the same time adding a failover server. Once I get my new Unity environment with failover up running and tested then I will move the failover server to our DR location in Tx. I won't be moving the failover server until next month sometime.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...