Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Multiflex Trunk - T1/E1 - Set to PRI_CPE Mode

Hello!

cisco 2821 with VWIC2-1MFT-T1/E1 - 1-Port RJ-48 Multiflex Trunk - T1/E1

How do i set it to PRI_CPE Mode?

I have connected it to another pri which cannot be change (set to pri_net)

Thanks!

controller E1 0/0/0
pri-group timeslots 1-31

interface Serial0/0/0:15
no ip address
encapsulation hdlc
isdn switch-type primary-qsig
isdn timer T310 120000
isdn protocol-emulate network
isdn incoming-voice voice
isdn supp-service name calling profile Network-Extension operation-value-tag local
no cdp enable
!

Everyone's tags (4)
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: Multiflex Trunk - T1/E1 - Set to PRI_CPE Mode

isdn protocol-emulate user

that is the default.

Note you never need to change times unless proven otherwise.

2 REPLIES
Hall of Fame Super Gold

Re: Multiflex Trunk - T1/E1 - Set to PRI_CPE Mode

isdn protocol-emulate user

that is the default.

Note you never need to change times unless proven otherwise.

Community Member

Re: Multiflex Trunk - T1/E1 - Set to PRI_CPE Mode

Thats it! Thanks!

899
Views
0
Helpful
2
Replies
CreatePlease to create content