Hi I have setup Mobile Voice Access (MVA), on my remote Site as it is my only h323 gateway. I can call in from my remote destination phone (PSTN phone) and the MVA recognizes the remote destination (RD).Once you enters the pin you get a menu with: 1.To dial a number ... 2.Enable .... 3.Disable .... When I press 1 I get prompted to enter the number followed by # when doing so the call gets immediately disconnected. I don't get a prompt stating the call can not be make or anything, the call just gets cut off.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...
You have reached the Cisco Logistics Support Center.. To Check Status of your RMA, visit Product Returns & Replacements (RMA).
Need help? Contact us by Phone or Email.
Phone: 1800 553 2447 Option 4