We have a CallManager 4.1(3)sr2 and our vm is unity express 4.3.1. We also have a QSiG to a BT Switch for turrets that our traders use. On the IP Phones the MWI works fine, however, on the turrets we are not getting MWI. We are not even seeing the MWI message being passed over the QSIG. Any ideas if this is a limitation of Unity Express, or QSIG integration with CallManager?
We have the same setup at our other sites but we are using Unity 4.01 instead of Unity Express and it works fine.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...