Hi. I have integrated CCM 4.2 with unity Cisco Unity 4.0 Build 4.0(2)
I have configured every think in the CCM end and unity end. But I have created mail box aswell and configured to go to voice mail after no answer.But after five rings it gives an message the call can not be completed as dialed. what could be reason. is there any other configuration has to be done in unity end like call handler etc...if any documents for unity integaration pls send it so that i can verify.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...