New at this: I've 2501 routers. How do I connect these routers to a switch or a pc in a production environment. I used the rollover and serial cables to configured the routers but I'm stuck connecting ethernet between the routers and pc or switch. (Note: my routers each has one AUI, 2 serial , one console, and one AUX.) I believe I need to use the AUI cable on the AUI port. I may need a cable with 15-pins on one end and RJ-45 at the other end. Is this right?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...