Newbie in CUCME - where do I should start?

[grzegorzniecka]

Dear all,

we plan to migrate our now exsiting IP telephony from AVAYA (PSTN gateway) to Cisco ISR G2 2921 (PSTN gateway) with CUCME.

Then, we plan to connect Cisco with Microsoft LYNC (SIP trunk?).

How can I start? For start I want to to configure one Cisco IP telephone with CUCME for tests.

Any help for the start should be appreciated

Regards

[ronpatel]

HI

Below is complete configuratoin document for CME

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmeadm.html

Note :- CUCILync with CME is not supported yet. SO it will not work with CME.

Regards

Ronak Patel

Please rate helpful posts.

[grzegorzniecka]

Thanks,

what do You mean by "CUCILync" ?

What I have read for now for integration CME and MS LYNC I have to set up SIP trunk.

Regards

[ronpatel · Accepted solution]

Hi,

CUCILync is plugin to integrate Lync with CUCM.

But even if you use SIP trunk, It is not officially supported as it is not tested yet by Cisco.

But for configuration purpose you can use following link. Configu wise it is same as OCS integration.

http://www.cisco.com/en/US/solutions/collateral/ns340/ns414/ns728/ns829/799011.pdf

Regards

Ronak Patel

Please rate helpful posts.

[grzegorzniecka]

Dear Ronak,

I have found this link:

http://jamesbotham.wordpress.com/2011/05/25/step-by-step-lync-2010-enterprise-voice-with-cisco-call-manager-express-or-uc500-part-2/

and there are differences than in Your link.

How can I start?

regards

[ronpatel]

Hi

The link which have given will not allow you to configure like three way conference.

Sorry I posted wrong link earlier. The below link shows the OCS with CME SIP integration. It should be same for Lync also.

http://www.cisco.com/en/US/solutions/collateral/ns340/ns414/ns728/ns829/817587_2.pdf

Regards

Ronak Patel