Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

NM-HDA Issues with CCM 4.1(3)

I am running into issues with a 2811 MGCP gateway running a NM-HDA module, I am unable to get the FXS ports (4 onboard) to register. The ports are configured as well as the dial-peers with the "service mgcpapp" command but the devices still don't register. Any help would be appreciated. IOS is 12.4(18).

1 REPLY
Community Member

Re: NM-HDA Issues with CCM 4.1(3)

The card had to be re-seated and worked after that, not sure why as the card showed up under the “show diag” prior to re-seating.

99
Views
0
Helpful
1
Replies
CreatePlease to create content