Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Not able to register IP communicator in CUCM

Hello,

I am having CUCM 8 installed and earlier i have registered 5 IP communicators in it. But recently i have deleted those IP communicators and now i am not able to register any IP communicator in  CUCM. Also checked in Device--Device Settings--Device Defaults and got nothing listed in box "Load Information". So is the problem because no firmware listed for communicator or anything else?

IP communicator always shows message"IP Configuring" and sometimes as "Registration Rejected:DBerror"

2 REPLIES
Cisco Employee

Not able to register IP communicator in CUCM

It's expected not to see a load there, that has nothing to do with this.

Registration Rejected:DBerror means that there is no config in CUCM to match that IPC.

Make sure you're properly configuring your IPC in CUCM.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Not able to register IP communicator in CUCM

Hi

Thnk you for your reply.

But i am configuring IPC well , as i have configured it before also. Still will check and revert. If you found any other issue then please reply.

732
Views
0
Helpful
2
Replies
CreatePlease login to create content