Notification on line group members with Cisco Unity connection 8
Sorry for this late response, javalenc!!!
Thanks for helps...
When you edit a message box, there is an 'Edit' where you can configure several options... and specially the MWI.
You could add extensions (DNs) on which notification should be shown. It works fine.
In my case, the users have just one problem : each member of the line group have it's own message box!!! So, they couldn't know from which message box the notification arrives. They have to look at their own message box and the one of the line group....
If they hasn't their own message box, it was possible to add their extensions (DNs) to the line group message box, and then easier to shown the messages.
Sorry for my bad english ;-) Hope it is understandable!!!
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.