I have an issue with OCS and Unity. Here is the scenerio: user dials Unity main extension from OCS dialpad. Unity then prompts for ID (exension). user dials extension. Unity error "I did not recongize that tone, please dial ID". user dials extension again. Unity error again, then company's main greeting plays. The reall issue is this only happens with one site. Other sites do not have this problem.
As long as all components are compatible, then the next step is to take a look at what Unity is receiving from the CM. In Tools Depot>Unity Diagnostic Tool, enable these mAcro traces: Call Control and Skinny TSP. Place a call to generate traces, then gather the svchost (for Skinny/SCCP) traces or the AvCsMgr traces (for SIP) that correspond to the timeframe of the test call. If Unity is receiving the correct digits from CM, then I'd suggest you open a TAC case to get help from there.
If Unity is not receiving the correct digits from CM, then I'd suggest setting/collecting/reviewing CM traces to see what is received from the OCS and what CM is sending to Unity.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...