Environment: 4 node cluster, with dedicated Pub and TFTP Server and 2 active Subscribers. We use a large quantity of Vg248s and 224s and have 2 PSTN gateways with 4 PRIs.
I am having trouble getting OP to Monitor all the devices. I am well under the limits of the software; 153 registered phones and 79 Total Devices; under Service Level View I click thru the Device Tree and I have a large quantity of grayed devices showing only IP address and not device names; this indicates they are not being monitored. What do I need to do to get them monitored? I have tried using Cisco Works DCR for Device Selection as well as Automatic and choosing "Voice and Telephony."
I've even tried adding a few 248s manually, but still show up grayed out.
Operations Manager uses similar calculations to diagnose both repeated restarts and flapping. Operations Manager considers a system to be restarting repeatedly when it performs too many cold or warm starts over a short period of time. Table H-1 lists the elements, traps, and user-defineable parameters that Operations Manager uses to calculate repeated restarts.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.